how to do Serial and Parrarell computing, multiple simulink models in a loop?

1 次查看（过去 30 天）
Mona Faraji Niri
Mona Faraji Niri 2019-9-4
评论： Nicolas B. 2019-9-6
Hi all,
I have two simulink files that need to run in a loop.
I have the first file sim1.slx that should run for some time and provide an output which is the input for sim2.slx. Then sim2.slx runs and afterwards it should get back to the first file sim1.slx and do this untill a counter reaches a limit.
I know that this is easy in codes and Matlab scripts, but my platform is only based on simulink.
has anyone any clues how to do this?
best regards
Mona

请先登录，再回答此问题。

回答（1 个）

Nicolas B.
Nicolas B. 2019-9-5
Hi Mona,
I would recommend you to take a look at the parsim command. Its documentation is very well done and give multiple examples.
Hope it helps.
Regards
  6 个评论
显示 4更早的评论
Mona Faraji Niri
Mona Faraji Niri 2019-9-5
if I put the first model in the Simulation> model Properties> callbacks > startFnc of the simulation configuration, this may run the first model and provide output to the second model. but how I can get back from model B to A again?
Nicolas B.
Nicolas B. 2019-9-6
The risk with what you are trying to do is that you will end up in an infinite loop because model A call model B and model B call model A.
However, if you really want to go that way, I would simply do the same thing in model B to call model A.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Coder 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by