PIL "rtiostream interface" timeout, f28377d, c2000

28 次查看（过去 30 天）
Timothy Scott
Timothy Scott 2019-9-8
移动：DGM 2023-12-2
I am able to deploy code generation onto the DSP (f28377d controlCARD R1.1).
However I can't execute a Processor-in-the-loop simulation. The serial comms seems to be issue.
I get the below error after program has been downloaded to target.
Can I get some suggestions on how to troubleshoot the issue?
Thanks v. much
The timeout of 10 seconds for receiving data from the rtiostream interface has been exceeded. There might be multiple reasons for this failure.
You should:
(a) Check that the target hardware configuration is correct, for example, check that the byte ordering is correct.
(b) Confirm that the target is running.
(c) Consider the possibility of application run-time failures (e.g. divide by zero exceptions, incorrect custom code integration, etc.).
Note (c): To identify possible reasons for the run-time failure, consider using SIL, which supports signal handlers and debugging.
If you cannot find a solution, consider using the method setTimeoutRecvSecs of rtw.connectivity.RtIOStreamHostCommunicator to increase the timeout value.
  3 个评论
显示 1更早的评论
Meenakshi RM
Meenakshi RM 2023-6-10
Hi,
May I know how you solved this problem?
Thanks,
Meenakshi
MERIEM
MERIEM 2023-12-2
移动：DGM 2023-12-2
Ihave the same problem could any on e solve it

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Venkatesh Chilapur
Hi,
Please contact :
https://www.mathworks.com/support/contact_us.html
Regards,
Venkatesh C

类别

在 Help Center 和 File Exchange 中查找有关 Processor-in-the-Loop Simulation 的更多信息

标签

产品


版本

R2019a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by