How can I add a block to a Simulink model in the center of the model view?

4 次查看（过去 30 天）
S. Boopalam
S. Boopalam 2019-10-7
评论： Artur Kaminski 2020-5-14
I can add a block to a model using the add_block, but I also want to change the Position parameter of the block to be approximately in the middle of the model. What commands can I use to get the coordinates for the center of the model viewing area?

请先登录，再回答此问题。

回答（1 个）

Jesús Zambrano
Jesús Zambrano 2020-1-1
Hi S. Boopalam,
Once you hav place the vlock using the command add_block, you can change the position of the block using the command set_param. For example:
vdp
set_param('vdp/Fcn','Position',[50 100 110 120])
To check the coordinates for the center of the model, you can place the block in the center an use the command get_param. For example:
get_param('vdp/Fcn','Position')
Hope this can help to solve your question.
  1 个评论
Artur Kaminski
Artur Kaminski 2020-5-14
You mean to find out where center is, you have to first manually put a block in the model, and then use get_param on the block to see the position, which would be center? What if I want to find center automatically?

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

产品


版本

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by