Change value of Simulink parameter inside of test harness to test two different variant subsystems
7 次查看(过去 30 天)
显示 更早的评论
Hello,
I need help to adapt simulink parameter EST_REF_VEL_RBT_MODE_CFG in test harness, so that I can test inside test harness (different ones are also possible) the variants shown below:
I am not able to change the value of the Simulink parameter since I get error
Constant or Parameter data EST_REF_VEL_RBT_MODE_CFG on left hand side of an expression.
as shown below:
How is it possible to adapt the given parameter value inside of test harness?
Thanks in advance.
Regards,
Samir Revelo
0 个评论
回答(1 个)
Fangjun Jiang
2019-10-25
Just change the value of EST_REF_VEL_RBT_MODE_CFG. When its value is 1, ERVRBTModeHandling is activated. When the value is not 1, ERVNoRBTMode is activated. That is how Variant Subsystem works.
2 个评论
Mahantesh
2023-2-20
@Samir Revelo Even I am facing same error, Kindly let me know if you have solved this or any alternative solutions which you might have tried.
Thanks in advance.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Outputs 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!