How to generate run to failure bearings data?

1 次查看（过去 30 天）
Krzysztof Lesniak
Krzysztof Lesniak 2019-10-25
回答： Luke Halberstadt 2020-12-22
Hi. I want to do a predictive maintenance system with Matlab but I don't have enough bearings data. Do you know hot to generate run-to-failure data in Matlab ? I don't care about bearings type or parameters ?
  2 个评论
HF
HF 2020-12-9
Hello, did you find a generator or some bearing data. If yes, could you please share those?
Kind regards

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Luke Halberstadt
Luke Halberstadt 2020-12-22
A digital twin can enable you to generate additional bearing data with some knowledge of your bearings. For an introduction, please read the paper by Steve Miller on Predictive Maintenance using a Digital Twin:
https://www.mathworks.com/company/newsletters/articles/predictive-maintenance-using-a-digital-twin.html
To dive deeper, you can take a look at the eBook linked below which refers to additional resources. Since you have limited data, you are probably going for a physics-based or combined physics and data-based. For this, Simulink and Simscape can handle solver behavior and physics equations to help you produce failure data for thousands of component lifetimes
https://www.mathworks.com/campaigns/offers/digital-twins-for-predictive-maintenance.html

类别

在 Help Center 和 File Exchange 中查找有关 Simscape 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by