TMS320F28379D: Code Generation Error while Using CLA Task Trigger block in Simulink
显示 更早的评论
Hello,
I am using Launchpad F28379D in Simulink. I have a problem while generating code for a CLA Task triggered subsystem which says 'can not open source file cla_header.h'. The model has a structure as follows:
Any help is appreciated.
回答（1 个）
Yash
2022-7-7
0 个投票
You should connect a CLA_Subsystem with the CLATaskTrigger instead of using a function interrupt. Checkout the code-gen variant of f280049C_DCDCBuck_PCMC. Go to PI_Controller_ISR and there you can find a CLA_Subsystem connected to CLATaskTrigger. Try to reproduce the same structure with f28379D.
类别
在 帮助中心 和 File Exchange 中查找有关 Texas Instruments C2000 Processors 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
