In my Simulink model I would like to conditionally write output data to selectable .mat files in different relative directories.

Question

Mark Wilson 2019-12-18

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/497311-in-my-simulink-model-i-would-like-to-conditionally-write-output-data-to-selectable-mat-files-in-dif

评论： Mark Wilson 2019-12-18

I have attempted to use a 'Switch Case' block with several 'Switch Case Action Subsystem' blocks, each containing a 'To File' block specifying a different relative directory and filename (.MAT). Unfortunately Simulink initializes empties (re-initializes) the MAt files specified in the non active Cases each run.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Mark Wilson 2019-12-18

My question is How do I prevent Simulink from re-initializing the inactive case 'To File' blocks ?

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Jim Riggs 2019-12-18

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/497311-in-my-simulink-model-i-would-like-to-conditionally-write-output-data-to-selectable-mat-files-in-dif#answer_407004

This sounds like a rather sophisticated way of constructing output. I'm not sure if that is easily acomplished with the "to file" block. I like to use S-functions to control my output.

In fact, I have an S-function that is the first block to run in my model (this is accomplished by placing it at the top level of the model and assigning it a priority = 1). this block reads a number from a file called "serialNumber", increments the number, and saves the incremented number bask to the "serialNumber" file. This serial number is used in other S-functions that generate output files, and appended to the output file name, so that every time I run the model the output is recorded in a new file with a "run number" attached to the file name. I can keep a log of all of the runs (date, time, run parameters), and pull up results for comparison (by run number) later. In fact, you can have the S-function that reads the serial number keep the run log in a file for you.