HDL Verifier: How to select the JTAG cable?

2 次查看（过去 30 天）
Daniel Kunz
Daniel Kunz 2019-12-19
回答： Kavya Vuriti 2020-3-31
I would like to use DataCapturing with HDL-Verifier. Therefore I am using a USB-Blaster which is connected to the FPGA board. Currently there are two
USB-Blasters in use which results in following error message:
Found more than one JTAG cable:
0:USB-BlasterII [USB-1]
1:USB-BlasterII [USB-2]
Please specify the correct cable name in the JTAGCableName parameter. For example, you can specify JTAGCableName as USB-BlasterII [USB-1];
Question:
How and where can I specify which JTAG cable shall be used?
thanks in advance

请先登录，再回答此问题。

回答（1 个）

Kavya Vuriti
Kavya Vuriti 2020-3-31
Hi,
To capture data from live FPGA into MATLAB workspace and to specify properties like 'JTAGCableType' and 'JTAGCableName', you could refer following documentation page: https://www.mathworks.com/help/supportpkg/xilinxfpgaboards/ug/hdlverifier.fpgadatareader-system-object.html
Hope this helps!!

类别

在 Help Center 和 File Exchange 中查找有关 FPGA, ASIC, and SoC Development 的更多信息

标签

产品


版本

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by