Where's the debug tab? Update: Solution found: Documentation didn't match Matlab-version!
显示 更早的评论
6 个评论
Walter Roberson
2020-1-18
In the menus,
Simulation -> Debug -> Debug Model
Image Analyst
2020-1-18
Not sure about Simulink because I don't have it, but in MATLAB the tool ribbon tab with all the debug commands is the Editor tab. Can't you just click around until you find it? Otherwise, can you click a little icon in the upper right corner of that popup window and tell it to dock that window?
Walter Roberson
2020-1-19
Current documentation on the Simulink tabs is not relevant to you. You should be referring to the documentation for your old release.
Starhowl
2020-1-20
采纳的回答
Hello Starhowl,
I have attached the steps to show the debug window. You need to place at least one Simulink block on the canvas to open the debug window.
After 19b, the menu was switched to the Simulink Toolstrip instead of the Simulink toolbar. 19a can use both.
Regards,
stozaki
更多回答（1 个）
Comcpu
2022-1-6
0 个投票
Hello Please go to model explorer then select your simulink model in model explorer window and then select Tools tab and then select Debugger...
类别
在 帮助中心 和 File Exchange 中查找有关 Event Functions 的更多信息
Translated by 
