Simulink Error Message "Derivative of state '1' in block ____ at time 0.0 is not finite. The simulation will be stopped. There may be a singularity in the solution."

Question

Ryan Kinzie 2020-1-20

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/501148-simulink-error-message-derivative-of-state-1-in-block-____-at-time-0-0-is-not-finite-the-simulat

评论： Hammed 2023-12-18

SimulinkModel.slx

I need help figuring out why I am getting the error message: "Derivative of state '1' in block 'SimulinkModel/EQ2 Intergrator' at time 0.0 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances) ". I have tried reducing the "Absolute Tolerance" in both the "Configuration Paramters" for the solver and each intergrator block's "Block Parameters". However, any combination of decreasing these values does not change the error message.

Please help me figure out why I am getting this error message and how to fix it.

Thank you

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Nishant Gupta 2020-1-24

4
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/501148-simulink-error-message-derivative-of-state-1-in-block-____-at-time-0-0-is-not-finite-the-simulat#answer_411745

In the Configuration Parameters, set the diagnostic "Inf or NaN block output" to 'error', you will get the following error:

"An error occurred while running the simulation and the simulation was terminated"

Caused by:

Block 'SimulinkModel/EQ2 Matrix Division 1' outputs 'NaN' for element 1 of output port 1 at major time step 0

This blocks has a divide by zero, which creates a Inf that is fed to an Integrator, generating this error.

So, avoid division by zero in the logic.

3 个评论
显示 1更早的评论隐藏 1更早的评论

Akshay Chandel 2021-6-23

Is anyone going to tell how to remove this error?

SALAH alatai 2022-12-30

anyone can help ?

请先登录，再进行评论。

Answer 2

Hammed 2023-12-18

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/501148-simulink-error-message-derivative-of-state-1-in-block-____-at-time-0-0-is-not-finite-the-simulat#answer_1373752

Continuous state '1' of 'FCCU/dTreg//dt/Integrator' at time 2.8042556824342819 is not finite. Simulink will terminate the simulation. There may be a singularity in the solution. Check the model 'FCCU' for errors. Try reducing the fixed step size or tighten the error tolerances for variable-step solvers.

please i need help on how to solve this issue