Matlab R2018a does not save the whole figure

Question

Orestis Stylianou 2020-1-21

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/501306-matlab-r2018a-does-not-save-the-whole-figure

编辑： Orestis Stylianou 2020-1-22

Hello,

I am working on some scripts that use this function (with some modifications). While the script is running the figure appears as expected. But when I export it, some parts of it are missing. I have tried

print(gcf, namem,'-dtiffn','-r600')

as well as manual export via the GUI. I keep getting the exact same parts cropped. What could be the issue? This is the 1st time facing such a weird problem.

2 个评论
显示无隐藏无

BN 2020-1-21

编辑：BN 2020-1-21

在 MATLAB Online 中打开

I have the same problem a few weeks ago. I told you what I've done, maybe useful for you. I'm worked with Matlab R2018b.

I was saved my work and close Matlab, then Restart the computer. after that I use:

clear all
close all
clc

Then I run my code from the first part again. After that everything was fixed for me.

I was saving the figure using this command:

DirectoryPath ='C:\Users\Behzad\Desktop\Figures';
whereToStore=fullfile(DirectoryPath,['filename', '.png']);
saveas(gcf, whereToStore);

I hope it helps you because I have exact same problem and it worked for me.

Also you can use export_fig instead of print.

https://www.mathworks.com/matlabcentral/fileexchange/23629-export_fig

BN 2020-1-21

在 MATLAB Online 中打开

Dear Orestis,

Acording to mac question, I think using this two line code the problem would be fix.

fh = figure() %your  figure
set(fh, 'Visible','off');

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Orestis Stylianou 2020-1-22

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/501306-matlab-r2018a-does-not-save-the-whole-figure#answer_411370

在 MATLAB Online 中打开

I just tried

fh = figure() %your  figure
set(fh, 'Visible','off');

still no luck

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Orestis Stylianou 2020-1-22

编辑：Orestis Stylianou 2020-1-22

在 MATLAB Online 中打开

So I spent a bit more time on this. By using the export_fig cutom function I can go up to a dpi of 432, after that parts of the image start missing. With using the usual print function that it was origianlly in my script and setting dpi to 522 I have no problem. When I set it to 523 pieces start missing. The higher the dpi, the larger the missing part is. 522 vs 600 dpi is not a big difference and it is sufficient enough but what is the cause of that?

EDIT: I had to set the renderer to painters and now it works just fine

print(gcf,namem,'-dtiffn','-r600','-painters');

Thanks :)

请先登录，再进行评论。