Simulation of PMSM Current Control using FCS-MPC
14 次查看(过去 30 天)
显示 更早的评论
Hi everyone
I'm trying to control a pmsm current using finite control set MPC, when I'm using PMSM model in simscape everything is fine and currents can track id and iq (currents in dq reference frame) but the problem is PMSM model is based on modified park transform (90 degree behind phase a) and our calculations are based on the original park.
when I change the PMSM model park transform to original park, the results change and FCS-MPC does not work properly.
does anybody have this problem?
Thank you in advance
2 个评论
Harish Kumar Coimbatore Rajaram
2020-4-16
Can you Share you Simulation file(Both Matlab script parameters used and the Simulink file) ??
回答(1 个)
Shang-Chuan Lee
2022-6-10
Hi Hossein,
It sounds to me the rotor angle definition of PMSM isn't aligned with your control algortihm where the Park/Clarke Transform on the dq-axis. I would suggest first check the current signals to the "Park Transform" block as well as the "Clarke Transform" block from the current measurement signals.
Best,
Shang-Chuan
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Permanent Magnet 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!