28379D GPIO INPUT
显示 更早的评论
Hi,
I want to use GPIO input and want to see incoming signal on my computer but incoming signal always seem as 0 Zero. How can I solve that?
Thanks.
2 个评论
Venkatesh Chilapur
2020-1-24
Hi,
Make sure you have configured correct GPIO pin in the GPIO block mask.
Ensure you are feeding the voltage to the corresponding pin the board as well.
You can always debug from CCS to verify the setup, we throw a link in diagnostic viewer to open the codegen project in CCS.
HTH,
Regards,
Venkatesh C
Yusuf Selim KARATAS
2020-1-24
回答（1 个）
Vishwa
2023-5-15
0 个投票
Hi,
To visualise data from Target Hardware in Simulink, you first need to perform "Monitor and Tune" in Simulink. Please refer to the following documentation:
Hope that helps!
Thanks
类别
在 帮助中心 和 File Exchange 中查找有关 Embedded Coder Supported Hardware 的更多信息
2020-1-23
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
