试用软件

28379D GPIO INPUT

5 次查看（过去 30 天）

显示更早的评论

Yusuf Selim KARATAS 2020-1-23

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/501664-28379d-gpio-input

回答： Vishwa 2023-5-15

Untitled.png

Hi,

I want to use GPIO input and want to see incoming signal on my computer but incoming signal always seem as 0 Zero. How can I solve that?

Thanks.

2 个评论
显示无隐藏无

Venkatesh Chilapur 2020-1-24

Hi,

Make sure you have configured correct GPIO pin in the GPIO block mask.

Ensure you are feeding the voltage to the corresponding pin the board as well.

You can always debug from CCS to verify the setup, we throw a link in diagnostic viewer to open the codegen project in CCS.

HTH,

Regards,

Venkatesh C

Yusuf Selim KARATAS 2020-1-24

yusufselim_model1.slx

Hi ,

Thanks for your answer. It seems that I do all of them. Can you check on my model please?

Thanks.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Vishwa 2023-5-15

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/501664-28379d-gpio-input#answer_1235024

Hi,

To visualise data from Target Hardware in Simulink, you first need to perform "Monitor and Tune" in Simulink. Please refer to the following documentation:

Signal Monitoring and Parameter Tuning over XCP on Serial - MATLAB & Simulink - MathWorks India

Hope that helps!

Thanks

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

类别

Code Generation Embedded Coder Deployment, Integration, and Supported Hardware Embedded Coder Supported Hardware Texas Instruments C2000 Processors

在 Help Center 和 File Exchange 中查找有关 Texas Instruments C2000 Processors 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Translated by

试用软件