In Hardware configuration with Simulink support package for parrot mambo, after pairing with bluetooth device, list of services in "open services" is empty. What Should I do?

Question

Paolo Ceppi 2020-1-31

编辑： Puru Kathuria 2020-12-22

I installed RNDIS driver after uploading the firmware with Simulink support package, so it should work.

My bluetooth adapter is a CSR Radio bluetooth and I installed its drivers from the CD provided with the adapter.

I can't figure out why I can't do a NAP connection with my mambo drone after I pair it. I can't find any services because the list is empty.

Please help me!

Thank you in advance!

Answer 1

Puru Kathuria 2020-12-22

编辑：Puru Kathuria 2020-12-22

Please make sure you are following the prerequisites before initiating the connection:

The Parrot® Mambo minidrone is switched on and the battery is charged.
Both the LEDs on the minidrone are green and blinking
And the drone is connected to your computer and is available in your computer's bluetooth devices.

For further information on how to setup bluetooth NAP connection to Parrot Mambo, please follow this link.

Also, follow this thread that deeply addresses the problem.

Hope it helps.