WHICH INPUT CHANNEL HAS TO BE INITIALIZED , analog input CH or digital input CH for DC VOLTAGE?

Question

MANJUNATH 2012-10-10

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/50399-which-input-channel-has-to-be-initialized-analog-input-ch-or-digital-input-ch-for-dc-voltage

HELLO,

i have DC voltage(2.5V) which i want to plot using NI USB 6255, whether i should use the analog input or digital HW channel has to be initialized.

even if i acquire data from digital i/o channel i will get logic 1 or logic0 so how to obtain the same voltage which i give as input

plz anyone help me

Manjunath

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Pedro Villena 2012-10-10

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/50399-which-input-channel-has-to-be-initialized-analog-input-ch-or-digital-input-ch-for-dc-voltage#answer_61514

编辑：Pedro Villena 2012-11-8

If you want to plot the exact voltage in matlab, use an analog input channel. The digital channels are in TTL range voltage (0-5 volts), and if you adquire a signal of 2.5V, you will get a noisy digital signal [0 1].

or

Try to configure the analog channel in Differential Mode. In this mode, you gonna use 2 channels, one for posistive pole, and the other for negative pole.

2 个评论
显示无隐藏无

MANJUNATH 2012-10-10

i want to plot 2.5V, its supply from battery (chargeable cell), i tried with analoginput but the plot was same even when the signal input was removed .

MANJUNATH 2012-10-11