Simulink data inspector missing some logged signals
显示 更早的评论
Simulink data inspector suddenly stopped logging some, but not all signals in my model. I can't think of any changes I would have made to the model that would have caused this. It seems that the data inspector is struggling to communicate with the model. I can stop logging signals that are currently working with the data inspector, but cannot start logging them again. I recently updated to matlab 2019b.
I've tried running >> Simulink.sdi.clear
Any help would be appreciated. Thanks in advance.
采纳的回答
Urmila Rajpurohith
2020-3-9
1 个投票
It may be due to "Output options" or "logging intervals".
refer to the below documents and select options in the model accordingly
Hope this helps!
1 个评论
Marcelo Fernandes
2021-5-13
Urmila, I am having the same issue when I try to save signals from the Simulink Data Inspector while using Simscape Fluids. When using Simulink.sdi.exportRun(LastRunID), some of the timeseries for some signals don't show up, although they exist when I use the simlog from Simscape. Do you have any other suggestions? Thanks!
更多回答（1 个）
Dominic Zucchini
2023-6-14
4 个投票
Hi,
I had a similar issue where signals I checked for logging in my model were not showing in the data inspector.
I found that Logging Mode was set to "Override" under Model Settings > Data Import/Export > Configure Signals to Log...
Switching the mode to "Log all signals specified in model" fixed the issue.
Regards,
Dom
类别
在 帮助中心 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
