How can I trip an ideal switch when a short circuit fault occurs.

3 次查看（过去 30 天）
MUHAMED SIDIBEH
MUHAMED SIDIBEH 2020-3-25
评论： Rusiru Sri 2020-11-18
I am simulating a Mechanical DC circuit breaker. I used a step to put on and off. I wanted to use a "compare to constant" block so that when the fault current goes over the threshold the ideal switch can trip. The step is connected to the ideal switch so I cannot connect a relay too. Any help will be much appreciated. Thanks
  5 个评论
显示 3更早的评论
Rusiru Sri
Rusiru Sri 2020-11-18
Hi,
I'm working on simulating a DC circuit breaking in Simulink and I'm still looking for a method to do that.
I really appreciate it if you could provide me any information regarding this simulation.
Thank you.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Rajat Tewari
Rajat Tewari 2020-6-9
Hello,
You can connect the relay output as the gate signal to the ideal switch and check if you are getting the expected output. Also add a powergui block to your model.
You can also refer to these links for implementing relays and circuit breakers:
  1. Relays
  2. Switches and Breakers
Hope it helps.

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

产品


版本

R2019a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by