Electrical Load Simulation for a House Simulink

Question

Jamie McFadyen 2020-3-26

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/513192-electrical-load-simulation-for-a-house-simulink

评论： Nirosh Mathew 2024-4-5

Hi,

I am looking for some assistance/advice on my simulation. I plan to simulate the electrical energy demand for a typical house over a 24 hour period, I have a fixed voltage source (from a fuel cell, not part of this simulation) 230V AC. In order to match the power demands from the house the current will have to increase or decrease. I have the power data required for a typical house and found how much the current will have to be during each half hourly increment (I=P/V) this has been put into a 1D look up table. Any advice or tips would be greatly appreciated

Below is what I have so far:

2 个评论
显示无隐藏无

JW 2020-9-8

Hi,

May i ask if you connect the 1D look up table to the MATLAB function block ?

Im currently simulating for a commercial load but instead of using 1D lookup table, i load the entire spreadsheet as my input to the MATLAB function block. However, im not able to connect the positive and negative terminal of the 230V AC source (as shown in the diagram below). If you're using MATLAB function block, may i know what do you code in MATLAB to do so?

Would appreciat if you could reply.

Nirosh Mathew 2024-4-5