How can I use Simulation Data Inspector (SDI) in External Mode with the TI C2000 Support Package?

1 次查看（过去 30 天）
MathWorks Support Team
编辑： MathWorks Support Team 2024-1-5
Hi, I am trying to log simulation data using the TI C2000 Support Package running my model in external mode. I understand I can log packets of data to individual MAT files and stitch them together, or use a scope with "Print to Figure" to extract the signal over the entire simulation. I followed the example listed here:
https://www.mathworks.com/help/releases/R2022b/supportpkg/texasinstrumentsc2000/ug/parameter-tuning-and-signal-logging-with-serial-external-mode.html
Is Simulation Data inspector (SDI) supported for this support package in external mode simulations?

请先登录，再回答此问题。

采纳的回答

MathWorks Support Team
编辑：MathWorks Support Team 2024-1-5
Yes, SDI is supported for TI C2000 Support Package running in External Mod, but only when running using the Universal Measurement & Calibration (XCP) protocol. "Classic" external mode over USB serial connection does not support SDI.
 
Please run the following command on MATLAB R2018a and refer to the section titled "Monitor and Tune over Serial Communication" in the documentation page:
web(fullfile(docroot, 'supportpkg/texasinstrumentsc2000/target-hardware.html'))
Please follow the below link to search for the required information regarding the current release:
https://www.mathworks.com/help/

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 ARM Cortex-M Processors 的更多信息

标签

产品


版本

R2018a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by