How to update a signal in Simulink

2 次查看（过去 30 天）
Nishant Kumar
Nishant Kumar 2020-3-30
评论： Nishant Kumar 2020-3-31
I essentially need to do 'x = x + a*b' operation at every time-step in my simulation. The value of b is changing throughout the simulation and the value of x is given initially. I tried using 'memory' block for the same but wasn't able to get the desired result due to sample time mis-match. The values are getting updated every 0.2 seconds whereas the step-time is 1s.
Please suggest what blocks I should use; if possible a diagram too. I think I need a block which can act as a source but also have an option to be updated. Or any other way to carry out the above task would suffice.
I have done this in Matlab script and it was very easy there, but I need a Simulink model solution.

请先登录，再回答此问题。

采纳的回答

Fangjun Jiang
Fangjun Jiang 2020-3-30
The true meaning of the equation is x=previous_x+a*b. Use the "Delay One Step" block (also called z-delay, unit delay, 1/z). The input is x, the output is previous_x, then construct your model.
  3 个评论
显示 1更早的评论
Fangjun Jiang
Fangjun Jiang 2020-3-31
You can specify the initial value for the z-delay block. It "gets updated everytime" when the simulation is run.
Nishant Kumar
Nishant Kumar 2020-3-31
Thanks a lot for help. This worked out fine for me.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 的更多信息

标签

产品


版本

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by