Changing Variable from logical to double
89 次查看(过去 30 天)
显示 更早的评论
Fx=edge(I1,'Sobel','vertical',0.001);
While executing above line the follwoing error message is received
"Variable Fx must be of data type double. It is currently of type logical. Check where the variable is assigned a value."
How change Fx type feom logical to double
8 个评论
Adam Danz
2020-4-3
编辑:Adam Danz
2020-4-3
Again, it makes no sense to me why this line
Fx=conv2(I,Gx);
would generate this specific error
Variable Fx must be of size [500 500]. It is currently of size [502 502] . . . . .
That line is merely assigning the output to variable Fx. I think the error is being generated somewhere else in a line where you're using the variable Fx. Could you provide a screenshot of the error and the code that causes the error? I'm unfamiliar with Coursera Matlab - does that mean you are running matlab online through a coursera portal or are you running Matlab on your computer using a license provided by Coursera?
To show that the code should not cause an error (given a proper image file), this runs fine:
RGB = imread('peppers.png'); % Built-in matlab file
I = rgb2gray(RGB);
Gx=[-1,0,1;-2,0,2;-1,0,1];
Fx=conv2(double(I),Gx);
采纳的回答
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!