Cannot select parameters to estimate using Simulink design optimization

Question

bit123 2020-4-5

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/515548-cannot-select-parameters-to-estimate-using-simulink-design-optimization

评论： Ben 2024-2-20

parameters.JPG

I have a Simulink model with 6 parameters of 6 gain blocks. I specified them as the Simulink parameters directly for each gain block in the model. I also specified 6 initial values for these parameters. Then, I used the parameter estimation function in the Simulink design optimization tool to estimate the 6 gain parameters following my input/output experiment data. But I could not select these parameters to estimate (the boxes next to the parameters could not be checked as in the attachment). I would appreciate if someone could advise me on this.

3 个评论
显示 1更早的评论隐藏 1更早的评论

ALESSANDRO GENTILI 2021-1-21

编辑：ALESSANDRO GENTILI 2021-1-21

I've found a solution for the Input Panel problem. I've simply added an input and output block (under sinks and sources), this way the Parameter Estimator can see the input.

Ben 2024-2-20

THANK YOU!!!!!!!! Also fuck matlab

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Farshid Naseri 2022-3-25

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/515548-cannot-select-parameters-to-estimate-using-simulink-design-optimization#answer_926739

In the model explorer, Model workspace the parameters to be estimated should be selected as "Matlab Variable" not a "Simulink Parameter".

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 2

Michael 2022-5-24

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/515548-cannot-select-parameters-to-estimate-using-simulink-design-optimization#answer_970975

If using the "Simulink Parameter" type, the variable itself is not numeric; instead, the numeric value is in the "Value" field. You can use the accordion at the bottom of the "Select model variables" dialog to specify indexing expressions. For example, if the Simulink Parameter variable is called b, then you can type "b.Value" in the edit-field, and then hit the "Enter" key.