How do I time synch 2 sensors with different sample rates and start/stop times?

1 次查看（过去 30 天）

Mitch Hezel 2020-4-10

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/517013-how-do-i-time-synch-2-sensors-with-different-sample-rates-and-start-stop-times

编辑： Mitch Hezel 2020-4-11

I have 2 sensors, A and B.

Sensor A is operating at 5Hz. Sensor B is operating at 100Hz. However, they are both the same type of sensor, and I can see that they are recording essentially the exact same waveform at some point in their respective collections, but their collections start and stop at different times. So sensor A may see the start of an event after 10 seconds (50 of its samples) and sensor B may see the same event after 2 seconds (200 of its samples). Is there an easy way to line these up? That is, upsample sensor A so it also sees the event at it's 200th sample? I would like Sensor A to be upsampled to Sensor B's sampling rate, probably using interp1.

Only one of the sensors is GPS timestamped, otherwise this would be fairly easy.

2 个评论
显示无隐藏无

Walter Roberson 2020-4-10

https://www.mathworks.com/help/signal/ref/dtw.html maybe?

Mitch Hezel 2020-4-10

Looks like it could be good, but MATLAB throws a memory error. The vectors I am using are pretty large: ~620k for sensor B and 58k for sensor A. It then tries to make an array of size 620kx58k.

I tried identifying maximum and minimum peaks near the beginning and end of each signal and clipping them so they both start and end at approximately the same reading, and then upsampling sensor A to sensor B using interp1. The beginning and end of the sensors align nicely, but there is a drift in the middle.

请先登录，再进行评论。

请先登录，再回答此问题。