Problem with running simulink block diagram in discrete mode

2 次查看（过去 30 天）

Pouya Jamali 2012-10-31

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/52357-problem-with-running-simulink-block-diagram-in-discrete-mode

I tried to run a Simulink block diagram which consists three difference blocks ... but it's not working properly ... I tried to diagnose the problem by monitoring the signal values. I found that the output value for the difference blocks is not used. I don't know what is this and what's the problem ... please help me

10 个评论
显示 8更早的评论隐藏 8更早的评论

Sachin Ganjare 2012-10-31

编辑：Sachin Ganjare 2012-10-31

Probabaly you did not check your output in scope correctly, rather take it in workspace & check, you will find non zero value as initial output

Pouya Jamali 2012-10-31

Ow, I think the problem is misunderstood ... I should explain it more efficient! using show port values I've monitored all the signals in my block diagram. all the signals are working properly just before passing through difference block. The output of the difference block is not used all the time during simulation. and I think it cause the final output to be zero which must be not.

请先登录，再进行评论。

请先登录，再回答此问题。