Is the Flight Controller Pixhawk 3 Pro is supported in "Embedded Coder Support Package for PX4 Autopilots" ?

1 次查看（过去 30 天）
Gaetan CHESNEAU
Gaetan CHESNEAU 2020-5-7
评论： Arun Mathamkode 2022-4-6
Please could you tell me please if the Flight Controller Pixhawk 3 Pro is supported in "Embedded Coder Support Package for PX4 Autopilots" ? Thank you for your help. Gaëtan

请先登录，再回答此问题。

回答（1 个）

Arun Mathamkode
Arun Mathamkode 2021-12-14
Although, Pixhawk 3 Pro is not supported officially, you can always use 'Pixhawk Series' as the target hardware to deploy code into Pixhawk hardwares by choosing the correct cmake. Note that the deployment to Pixhawk 3 Pro is not offcially verified.
  1 个评论
Arun Mathamkode
Arun Mathamkode 2022-4-6
To use these boards, you can select "My board is not listed here" in hardware setup screen (instead of selecting one of the supported boards) and use the Target Hardware as PX4 Pixhawk Series in Simulink. See the full documentation on how to use a board that is not officially supported but belongs to the FMU standard

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 PX4 Autopilots 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by