driven a ball following a predefined trajectory in simmechanics
显示 更早的评论
Hi,
I am new for simmechanics. My job is driven a massless ball to follow a predefined trajectory in a plane and the coordinates of the ball at any given time is known.
I tried to connect a small ball with the ground with a in-plane joint then using a liner driver to move it. However, I can only connect one linear driver to it. Because each linear driver can only control one degree of freedom, it is not enough for me to duplicate the 2D trajectory. Attempts to connect two linear drivers at the same time failed.
I would like to know:
1. Is there any alternative approach to realize my task? 2. Is there any example that I can follow?
Thank you in advance.
Best.
Ming
回答（2 个）
Raju Purohit
2012-11-4
0 个投票
It is possible!
I am pretty sure where you have gone wrong. In the block parameters of your second joint actuator, you perhaps have forgot to change "Connected to primitive" to "P2". If it is "P1", redundancy will exist as two actuators will try to actuate the same 'degree of freedom' of the joint.
Hope this helps.
类别
在 帮助中心 和 File Exchange 中查找有关 Assembly 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
