清空筛选条件
清空筛选条件

driven a ball following a predefined trajectory in simmechanics

2 次查看（过去 30 天）
Ming
Ming 2012-11-1
Hi,
I am new for simmechanics. My job is driven a massless ball to follow a predefined trajectory in a plane and the coordinates of the ball at any given time is known.
I tried to connect a small ball with the ground with a in-plane joint then using a liner driver to move it. However, I can only connect one linear driver to it. Because each linear driver can only control one degree of freedom, it is not enough for me to duplicate the 2D trajectory. Attempts to connect two linear drivers at the same time failed.
I would like to know:
1. Is there any alternative approach to realize my task? 2. Is there any example that I can follow?
Thank you in advance.
Best.
Ming

请先登录，再回答此问题。

回答（2 个）

Ming
Ming 2012-11-1
The problem is solved. The two linear driven solution works for this problem. However, is there any other more convenient solution?
Thank you.
Raju Purohit
Raju Purohit 2012-11-4
It is possible!
I am pretty sure where you have gone wrong. In the block parameters of your second joint actuator, you perhaps have forgot to change "Connected to primitive" to "P2". If it is "P1", redundancy will exist as two actuators will try to actuate the same 'degree of freedom' of the joint.
Hope this helps.

类别

在 Help Center 和 File Exchange 中查找有关 Assembly 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by