Connecting 2 signals in Simulink gives an error about data type

1 次查看（过去 30 天）
Justyna Fedko
Justyna Fedko 2020-5-11
回答： Guru Mohanty 2020-5-14
I'm trying to show on scope 2 signals - one is bit stream and the other one is the result of multiplication. Occured error is visible in attach.
Without scope3 plugged my model works properly and gives expected results.
Can you halp with that?

请先登录，再回答此问题。

回答（1 个）

Guru Mohanty
Guru Mohanty 2020-5-14
Hi, error in the model is due to the Product block. Its two inputs are of datatype 'int8' and 'double' and the output is of type 'double', but the wire expects a signal of type 'int8'.This causes an error. In this scenario, you can use Datatype Conversion Block or you can set the Output datatype of the product block.

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by