An error occurred while calling into the SIL or PIL target connectivity implementation.

10 次查看（过去 30 天）
N/A
N/A 2020-5-16
评论： Azizhan 2023-3-13
Hello
I an trying to performe a Processor-In-Loop (Raspberry Pi) simulation for a simple model in Simulink.
I always get this error message (shown in attached picture):
An error occurred while calling into the SIL or PIL target connectivity implementation.
Caused by:
  • Invalid Simulink object name: Subsystem
  • The block diagram 'Subsystem' is not loaded.
I am not an expert, but here is my workflow :
1) From configuration parameters/solver set automatic solver selection.
2) From configuration parameters/hardware implemention set hardware board as Raspberry pi, and confirm the IP address, username, and password.
3) Form configuration parameters/code generation/interface check contineous time.
4) Form configuration parameters/code generation/verification/create block >> PIL.
5) Treat the subsystem as atomic.
6) Deploy the selected subsystem to hardware, copy the created PIL block to my model, then run the simulation.
Am I missing something?
  3 个评论
显示 1更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Raspberry Pi Hardware 的更多信息

标签

产品


版本

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by