I can't solve errors from output error status of creating PWM signal(example of Embedded coder support package for PX4 autopilot)
显示 更早的评论
Hi, I'm trying to make PWM signal from my px4 hardware(Pixhawk1) with the example 'Getting Started with PWM Blocks for PX4 Autopilots' from Embedded coder support package for PX4 Autopilot.
I executed the example(monitor and tune), however, the output error status of PWM block indicated my error states.
I found the meanings of the error, however, I can't how to fix them.
How can I find solutions of my errors?
2 个评论
David Fink
2020-5-18
It sounds like you found the error code table on this page:
lim daehee
2020-5-18
回答（1 个）
Arun Mathamkode
2021-12-6
0 个投票
As per your discription the issue is resolved after caliberating the RC transmitter. I am just reposting it as an answer so that it helps anyone who may be looking for this issue. .
类别
在 帮助中心 和 File Exchange 中查找有关 Waveform Generation 的更多信息
2020-5-17
2021-12-6
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
