0 个投票

Hi,
I am trying to run SDRuReceiver command with platform 'N321' (or 'N320/N321') but I got the following error.
Error using comm.internal.SDRuBase
"N320/N321" is not a valid value for the Platform property. Valid values are: "B200" | "B210" |
"N200/N210/USRP2" | "X300" | "X310".
However, as mentioned in the link below N321 is a supported board for this command.
https://www.mathworks.com/help/supportpkg/usrpradio/ug/comm.sdrureceiver-system-object.html
Please let me know if you have any suggestions.
Thanks

2 个评论
显示 无 隐藏 无

chengmao Zhou
chengmao Zhou 2021-5-14
Hello,I want to use N321 in matlab too.But I have some problems when I setup the N321.Did you successfully set up N321?
Mohammad Torabi
Mohammad Torabi 2021-5-14
Hi, I did not use Matlab anymore, just the UHD.

请先登录，再进行评论。

请先登录，再回答此问题。

 采纳的回答

Sai Sri Pathuri
Sai Sri Pathuri 2020-5-26

0 个投票

The support for USRP N320/321 radio is introduced in R2020a. You may see the R2019b documentation below. N320/321 was not listed in Platform.
https://www.mathworks.com/help/releases/R2019b/supportpkg/usrpradio/ug/comm.sdrureceiver-system-object.html#bun592c-1-Platform
I assume you are using an older version of MATLAB and the error might be because of that. You may upgrade to R2020a to use N321 radio.

2 个评论
显示 无 隐藏 无

Mohammad Torabi
Mohammad Torabi 2020-5-26
Thanks for your reply.
Yes, you are right, I am using R2019 version. I will upgrade to R2020 and if I had a question I will let you know.
chengmao Zhou
chengmao Zhou 2021-5-14
Hello,I want to use N321 in matlab too.But I have some problems when I setup the N321.Did you successfully set up N321?

请先登录，再进行评论。

更多回答（0 个）

类别

在 帮助中心 和 File Exchange 中查找有关 Communications Toolbox 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by