simulink coder - code generation not visible in configuration parameter pane

Question

Ingrid 2012-11-12

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/53510-simulink-coder-code-generation-not-visible-in-configuration-parameter-pane

编辑： Hammed Omotoso 2022-10-19

I am very new to simulink and I am trying to figure out how I can convert a model that I created to s-code so that I can use it as a user-defined block (S-function) in my other code.

I first tried to reference to my own created model through a Ports & Subsystems/Model block but this did not work out in my case because than a file is generated for each time the model block is referenced which I do not want due to memory problems and is also irrelevant because the block does not change...

Therefore my solution to circumvent this problem was to create s-code from the model and then reference to this s-code in my topmodel. So* first question*: is this the good way to approach this?

Second question: where can I find the code generation pane? I have checked and have the simulink coder installed (command ver shows: Simulink Coder Version 8.2 (R2012a) but I cannot find it on the configuration pane (see picture attached) nor in the model explorer. In the help of the simulink coder this option should be there and I have no idea were to look further... )

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Kaustubha Govind 2012-11-12

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/53510-simulink-coder-code-generation-not-visible-in-configuration-parameter-pane#answer_65133

在 MATLAB Online 中打开

See Create S-Function Blocks from a Subsystem for information on you can use Simulink Coder to generate an S-function from a subsystem.

What do you see when you execute:

>> license('checkout', 'real-time_workshop')

If you don't see 1 as the return value, you are probably not seeing the Code Generation pane in the Configuration Parameters window because Simulink is unable to check out a license for Simulink Coder (formerly known as Real-Time Workshop).

3 个评论
显示 1更早的评论隐藏 1更早的评论

Ingrid 2012-11-13

Okay, I have contacted our ict-service and apparently I will not be able to obtain the license for the simulink coder as it reserved for specific departments.

Any ideas on how I can solve my problem stated above without the simulink coder?

Is it better to work with model-references or with subsystems or ... The reason that I worked with model-reference is that I have a certain set-up that needs to be repeated within one top-model at different locations and I build this top-model with matlab-code (add_block)

Ingrid 2012-11-13