Is it necessary to perform a load flow prior to run the power_3levelVSC file?

Question

Juan Antonio Cabeza López de Tamayo 2020-6-7

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/543908-is-it-necessary-to-perform-a-load-flow-prior-to-run-the-power_3levelvsc-file

评论： Juan Antonio Cabeza López de Tamayo 2020-6-13

Good afternoon, in this file a PWM converter is connected to a grid. My question is whether it is necessary or not to perform a load flow before simulating this file.

If not could you please suggest other cases where a previous load flow is required to set the values of the blocks? Thanks in advance!

Juan Cabeza

jaca1810eng@gmail.com

Research Gate: Juan Cabeza

Twitter: @jaca1810eng

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Joel Van Sickel 2020-6-8

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/543908-is-it-necessary-to-perform-a-load-flow-prior-to-run-the-power_3levelvsc-file#answer_448145

Hello Juan,

due to the power electronics involved and how they are modelled in this model, the load flow option would not work. Instead, this model was run to steady state, and those states were saved and then put in as initial conditions.

Here are some models that use load flow. Unfortunately, if your main goal is the power electronics simulation, this type of work flow won't be useful for you.

https://www.mathworks.com/help/physmod/sps/examples/emergency-diesel-generator-and-asynchronous-motor.html

https://www.mathworks.com/help/physmod/sps/examples/ieee-13-node-test-feeder.html

https://www.mathworks.com/help/physmod/sps/examples/initializing-a-5-bus-network-with-the-load-flow-tool-of-powergui.html

Regards,

Joel