Unable to get shared memory page. Make sure that your model either consists a Simulation step or an Analysis step block.

13 次查看（过去 30 天）

Martin Boehme 2020-7-1

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/557653-unable-to-get-shared-memory-page-make-sure-that-your-model-either-consists-a-simulation-step-or-an

评论：哲 2025-2-11

Dear ladies and gentlemen,

i am trying to use MATLAB/Simulink with CANOE. I have integrated CANOE Signal Output blocks in my model. Whenever i start the model i get the following error:

Error reported by S-function 'sigout' in 'xxxxxx/Signal Output/S-Function':

ERROR in block 'xxxxxxxx/Signal Output/S-Function': Unable to get shared memory page. Make sure that your model either consists a

Simulation step or an Analysis step block.

I cant find help for this error so far.

Does anybody know the problem and is able to help me?

Thank you!

Martin Sommer

6 个评论
显示 4更早的评论隐藏 4更早的评论

江波丁 2021-7-20

@Martin Boehme I am meeting the same problem with MATLAB 2019a&CANoe 11 SP1, could you please help me to check whether they match or not? Thanks a lot.

Martin Boehme 2021-7-20

For my case it was a problem that Matlab and Canoe version were not compatible. So what you need to do is check, whether your two diferent SW versions are compatible

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Omkar Karve 2021-10-22

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/557653-unable-to-get-shared-memory-page-make-sure-that-your-model-either-consists-a-simulation-step-or-an#answer_814228

Canoe_Matlab_Compatibility.png

I have an update from Vector support on this issue. Attached is the chart showing which Canoe version supports which Matlab version. Hope this helps someone.