Arduino Uno connection using the 1 wire library

2 次查看（过去 30 天）

Andrew Loots 2020-7-23

评论： Rohan Kale 2020-10-1

When initiating the Uno without the library it works. I can also write to uno with IDE.

When I specify the Paulstoffregen/OneWire library I get the following fault message.

"Cannot program board uno ( COm5)"

Rohan Kale 2020-10-1

Hi Andrew,

Can you please:

specify the MATLAB version you are using for the same
share the error logs for the same. The debug messages can be enabled with the TraceOn option as follows:

>> a = arduino('COM5', 'Uno', 'Libraries', 'PaulStoffregen/OneWire', 'TraceOn', true)

confirm if you have downloaded the correct library, renamed it to OneWire, and added to the libraries folder. The error can occur if the third party is not found in the libraries. In fact, the error log might actually point out that this lib is missing. Please refer to Steps 1 to 3 on the FEX page

Hope it helps