add_line for single source and multiple destination

Question

Shankar Santhosh 2020-8-10

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/577636-add_line-for-single-source-and-multiple-destination

回答： Monisha Nalluru 2020-8-13

Looking for any simple way to add a line programmatically from output of a block(say Constant block) to more than one destination blocks(Eg., OutPort and Scope).

I Expect something like,

Any suggestions?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Monisha Nalluru 2020-8-13

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/577636-add_line-for-single-source-and-multiple-destination#answer_478977

在 MATLAB Online 中打开

add_line function is used to connect the signal between block.

To add a line programmatically from output of a block to more than one destination blocks you can below code as example

open_system(new_system('connect_model'));
add_block('simulink/Commonly Used Blocks/Constant','connect_model/Constant');
set_param('connect_model/Constant','position',[220,80,295,120]);
add_block('simulink/Sinks/Out1','connect_model/Out1');
set_param('connect_model/Out1','position',[220,80,260,120]);
add_block('simulink/Sinks/Scope','connect_model/Scope');
set_param('connect_model/Scope','position',[235,162,280,218]);
add_line('connect_model','Constant/x','Out1/4');
add_line('connect_model','Constant/x','Scope/1');