add_line for single source and multiple destination

12 次查看（过去 30 天）
Shankar Santhosh
Shankar Santhosh 2020-8-10
回答： Monisha Nalluru 2020-8-13
Looking for any simple way to add a line programmatically from output of a block(say Constant block) to more than one destination blocks(Eg., OutPort and Scope).
I Expect something like,
Any suggestions?

请先登录，再回答此问题。

回答（1 个）

Monisha Nalluru
Monisha Nalluru 2020-8-13
add_line function is used to connect the signal between block.
To add a line programmatically from output of a block to more than one destination blocks you can below code as example
open_system(new_system('connect_model'));
add_block('simulink/Commonly Used Blocks/Constant','connect_model/Constant');
set_param('connect_model/Constant','position',[220,80,295,120]);
add_block('simulink/Sinks/Out1','connect_model/Out1');
set_param('connect_model/Out1','position',[220,80,260,120]);
add_block('simulink/Sinks/Scope','connect_model/Scope');
set_param('connect_model/Scope','position',[235,162,280,218]);
add_line('connect_model','Constant/x','Out1/4');
add_line('connect_model','Constant/x','Scope/1');
Customize code according to add more blocks and signals between blocks.
Hope this helps!

类别

在 Help Center 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by