Gimbal Joint -- Simscape -- Singularity

3 次查看(过去 30 天)
Hello everyone,
When I was trying to aimulate more than 90 degree with Gimbal Joint on Y and Z axis. I always have a problem with singularity. The problem is caused by Gimbal Joint.X axis. Anyone knows how should I can solve this problem? The other side, I dont have any problem with X axis. I can simulate more than 90 degree.
Thank you very much in advance.
Here is the error message.
Derivative of state 'Sensor.Gimbal_Joint.Rx.w' in block 'Sensor/Gimbal Joint' at time 0.766 is not finite.
The simulation will be stopped. There may be a singularity in the solution
If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)

回答(1 个)

Steve Miller
Steve Miller 2021-6-5
A Gimbal Joint can be oriented into a singularity if two of the axes align perfectly, as two of the degrees of freedom are then aligned. You can swap in a Spherical Joint to avoid this problem.
--Steve
  1 个评论
Muhammad Fairuz
Muhammad Fairuz 2022-9-7
Hi Steve,
I need to define upper and lower limit, joint stiffness and damping for each rotational axis. Due to this reason, I am using gimbal joint insteads of spherical joint (can only configure for one x-axis).
Any idea to find way around this issue? I am having gimbal lock issue.
Thanks

请先登录,再进行评论。

类别

Help CenterFile Exchange 中查找有关 Assembly 的更多信息

产品


版本

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by