problems using Start in Data Acquisition script

2020 8 14
2 个回答
回答已采纳
更新时间：2020 9 4
5 次查看（30 天）

0 个投票

I have a very basic script here. im running Matlab 2020a with the Data Acquisition Toolbox installed to gather data from a NI USB 6289 DAQ. the code is below
clear all
d = daq("ni");
ch1=addinput(d, "ThunderdomeDAQ", "ai0", "Voltage");
start(d)
data=read(d);
pause(5);
stop(d);
however, every time i run the code, it returns an error for the line start(d) is on. the error says:
Unrecognized method, property, or field 'doWriteDataLastBlock' for class 'daq.ni.ChannelGroupAnalogInput'.
it returns the same error if i use start(d,"Continuous") as well. also, if i use data=read(d, seconds(1)) instead of start(d).
anyone have any ideas?

请先登录，再回答此问题。

 采纳的回答

scott siler
scott siler 2020-9-4
编辑：scott siler 2020-9-4

0 个投票

finally resolved this issue with Tech Support's help. they were surprised about the answer as well. so, i set the name of my DAQ to 'ThunderdomeDAQ', which it has been for years, and worked fine on Matlab 2018a. i recently updated my software to Matlab 2020a and apparently in 2019 or 2020, something was changed in the software. Now if you change the name of your DAQ to anything including 'do', your program will not work. it really is as simple as that. i changed the name to "Thunderd0meDAQ' and it works.

更多回答（1 个）

0 个投票

Hi
Maybe you should add data rate, e.g.:
D = daq("ni");
D.Rate = 5000;
addinput(D, "ThunderdomeDAQ", "ai0", "Voltage");
D.Rate = 5000;
data=read(D, seconds(5)); % Collect data for 5 sec

1 个评论
显示 -1更早的评论 隐藏 -1更早的评论

scott siler
scott siler 2020-8-14
thanks for the response Sulaymon.
just tried it. no change. still throws the same error response for the line data=read(D, seconds(5));

请先登录，再进行评论。

类别

在 帮助中心 和 File Exchange 中查找有关 Data Acquisition Toolbox Supported Hardware 的更多信息

产品

版本

R2020a

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by