Persistent variable 'count' is undefined on some execution paths when using embedded matlab function
显示 更早的评论
I am using the embedded matlab function with constant 1 as the first input and a step signal as the second input (initial value to be 1 and then after a stepsize it becomes 0). The code for the matlab function is as follows:
function sys = fcn(u)
persistent count;
if u(2)>0
count=0;
else
count=count+0.01;
end
sys=u(1)+count;
end
The error shows that: Persistent variable 'count' is undefined on some execution paths**
When I changed the embedded matlab function to s function and used the same code again, there is no error. Why is this code not valid within the embedded matlab function? Thanks for the reply.
采纳的回答
Image Analyst
2013-1-4
编辑：Image Analyst
2013-1-4
If you enter the function with the second element of "u" less than zero, it's possible to execute the "count=count+.01" line, which may have count undefined is you never did the first part of the if block. I would think it would be a warning, not an error during editing time, but an actual error if you hit that line with count undefined during run-time.
And I don't know what an " s function" is, and I don't have the embedded toolbox so I don't know about your latter sentences.
Try it like this:
persistent count;
if isempty(count)
count = 0;
end
if u(2)>0
count=0;
else
count=count+0.01;
end
sys=u(1)+count;
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 MATLAB Coder 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
