Cannot boot RTTarget-32 from Virtual 8086 mode

hong feng

2013 1 5

0 个回答

3 次查看（30 天）

0 个投票

Hi, when took an example about xPC Target Stand Alone in matlab help 2012b, i took the steps in the help, and the only different was tha i had not edit the autoexec.bat located in the C:\ with dos commands, i edit it in xp with txt in xp syttem insteard, and when i finished transfering file from the host computer to the target computer and editing the autoexec.bat. i reboot my target computer in dos system, but the system returned some information as below: "RTTarget-32 DOS Boot Utility 5.23(c) 1996,2011 On Time Informatik GmbH Cannot boot RTTarget-32 from Virtual 8086 mode"

and the target computer had not run the model i transfered to it, could anybody give me some favour about these prombles, or is there anybody who met the same problems.

3 个评论
显示 1更早的评论隐藏 1更早的评论

hong feng 2013-1-6

I refered to a document named "What Is xPCBox" for matlab2006b, and it says that problem is because the target do not support config.sys, and I edit the config.sys as segestion, but I met a new problem, the dos system returned information as: "Address 101000h not available", I really have no ideas what is the wrong, and is there something wrong with my DOS system?

hong feng 2013-1-9

I have solved the problem above, as my DOS version is 7.10 with many externed funtions, but the matlab does not support config.sys, so i have two choices to solve the problem: reinstall the DOS system as an minimal system or delete the config.sys file in the C:\ directly.

请先登录，再进行评论。

请先登录，再回答此问题。

Follow Question