How can I insert proper tex interpreter inside figures?

1 次查看（过去 30 天）
Hassan F
Hassan F 2013-1-7
When I try to add greater or equal sign to my figure, it is shown as '?'. To my surprise most of the tex symbols are not properly displayed.
I have tried the following, but none has worked so far:
  • add all MATLAB fonts to FontBook (OS X)
  • specifically switching interpreter to tex
When I use latex as my interpreter, however, it appears properly. But I can't control fontname properties to match other texts on the figure.
Any ideas what is going on here?
My MATLAB version is R2012a and OS X 10.8.2.
  5 个评论
显示 3更早的评论
Hassan F
Hassan F 2013-1-8
编辑：Hassan F 2013-1-8
My Matlab version is R2012a.
There is no problem when I save figures as pdf or eps (*). I suspect there is a problem with the fonts installed on X11.
(*) edit: interrogation sign appears properly when I save in these two formats.
José-Luis
José-Luis 2013-1-8
You could check if you have Tex Computer Modern in Fontbook. If they are not in your system, that could be the problem.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Daniel Shub
Daniel Shub 2013-1-8
While my guess is that their is probably a much simpler solution (like install the correct fonts). The TeX interpreter is fully configurable (although poorly documented). See this question.

类别

在 Help Center 和 File Exchange 中查找有关 Language Support 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by