Adams-simulink cosimulation error

Charles Nutakor

2020 8 21

0 个回答

1 次查看（30 天）

0 个投票

I am trying to run a simulink model (for which the topology has not changed ) in MATLAB R2019a. The model was previously saved with an old MATLAB version (R2013a.

Whenevr I try to run the model following error appears

'Cannot compile the model. The model topology has been illegally changed since the model entered Restricted mode. Please restore the original model topology, or switch to Full mode'.

Also, I tried saving the model in R2019a version but could not.

2 个评论
显示无隐藏无

Debasish Samal 2020-8-24

编辑：Debasish Samal 2020-8-24

Hello Charles,

I understand that you are trying to run a simulink model in newer MATLAB R2019a version which was created with an older MATLAB R2013a version. I assume that the model was saved in Restricted mode in MATLAB R2013a.

A similar issue can be found in the following answer:

https://www.mathworks.com/matlabcentral/answers/482825-why-i-see-an-error-about-model-topology-when-using-restricted-mode-with-simscape-by-simulating-a-mod

Another possible workaround is suggested in the second 'Note' of the following documentation:

https://www.mathworks.com/help/physmod/simscape/ug/about-the-simscape-editing-mode.html?s_tid=srchtitle

Hope this resolves the issue.