the scope doesn't show the correct signal

4 次查看（过去 30 天）
Cristian David Navarro Suárez
回答： Vasco Lenzi 2020-8-28
i'm trying to simulate a simple AC circuit in simulink, i put a sinusoidal signal in a AC voltage source with 50V peak, and a resistance of 10 ohms in serie with the voltage source, that's all the circuit, when i measure the voltage using the scope it works and i see the correct waveform, but when i look for the current using the scope i don't see anything, (i am measuring the current in serie with the resistence and the voltage source)

请先登录，再回答此问题。

采纳的回答

Vasco Lenzi
Vasco Lenzi 2020-8-28
Hi Cristian
you modeled the circuit as open. Putting a voltage sensor there won't close the circuit to allow current to flow. So the result are correct. You need to properly close the circuit and place the sensor appropriately:
see this shipping example as well:
>>power_acvoltage

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Electrical Sensors 的更多信息

标签

产品


版本

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by