connecting the output microcontroler AT89S52 at matlab

Question

Soni huu 2013-1-22

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/59498-connecting-the-output-microcontroler-at89s52-at-matlab

How to know the output of microcontroler program on matlab can be read real time

2 个评论
显示无隐藏无

Walter Roberson 2013-1-22

Are you trying to read a particular pin from it, or are you trying to read the UART?

A microcontroller such as that one needs to be mounted in a board. Is that board then placed internally in your system such as a PCI board, or is it an external board with output connectors (e.g., a serial port)

Does the system you are running MATLAB on have a serial port, or does it only have a USB port?

Soni huu 2013-1-23

编辑：Soni huu 2013-1-23

yes,...i read the pin microcontroler via RS232 circuit with usb port

matlab read and run directly the system that comes the usb port through the RS232 series from pin microcontroler

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Walter Roberson 2013-1-23

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/59498-connecting-the-output-microcontroler-at89s52-at-matlab#answer_72067

What does "real time" mean in this situation? USB uses a polled shared-bus packet protocol that is not able to transfer data immediately after the data is generated. By default, USB serial ports collect characters until the packet is full or there have been no new characters for 20 ms. There is a way for controlling software on the transmitting end to request that all accumulated data be sent as soon as possible, but that has to be done on the transmitting end (e.g., at the microcontroller end if you are transmitting data from there); MATLAB does not have any interface to request immediate transfer when MATLAB is doing the transmitting.