Stateflow, Determine Initial State

Question

André Hvatum 2020-9-24

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/599134-stateflow-determine-initial-state

评论： André Hvatum 2020-9-28

I'm using the stateflow toolbox to track and control the states of an external physical unit. I'm reading a feedback signal from the unit telling me which state it's in, and sending the correct command signal (depending on current state) to bring it to the next desired state. During startup of the system, the unit could be in any state. Basically, the initial state is unknown (must read feedback signal to determine it) since I'm not controlling it. What’s the best way to configure this in the Stateflow chart? Current solution is to have a dedicated "dummy" initial state, which (depending on value of feedback signal) transitions directly to the correct actual starting state of the unit. This clutters the chart a bit, and there’s probably a more elegant way. I could probably use transition tables, but can these be combined for example, so I use a chart like now, but a table just to get the starting state right?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Nicolas Schoonbroodt 2020-9-28

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/599134-stateflow-determine-initial-state#answer_501508

It's also possible to use a junction: connect the default transition to a junction (a circle) and from that junction, have transition to the different possible initial state with conditions on these transition. (be sure to have one valid path to a default state in all cases)

State machine with several possible initial state

3 个评论
显示 1更早的评论隐藏 1更早的评论

Nicolas Schoonbroodt 2020-9-28

Yes it makes a lot of sense. I would say that both approachs have positive and negative, but they are functionally equivalent.

As you say, the use of one defaut transition with multiple transition from that junction add a lot "cluttering" due to the many transitions, but in term of readability it has one advantage: there is only one default transition, meaning that it's easier for a reader to see all possible states starting from that point.

The many default transition has the exact opposite: less transitions polluting the chart, but a potential reader has to "find" all possible starting transition.

I think the choice between the two is more a preference matters (either personal preference, or company modeling guidance)

André Hvatum 2020-9-28

Thanks again for clarifying :)

请先登录，再进行评论。

Answer 2

Fangjun Jiang 2020-9-24

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/599134-stateflow-determine-initial-state#answer_499732

Use the default transition to pick any state as your initial state.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

André Hvatum 2020-9-24

Thanks! You mean add a "default transition" arrow to each of the states? I didn't think this would work since I didn't see how to add condition to it. But I see now this is straightforward... Will give it a try, thanks again!

请先登录，再进行评论。