Algebraic loop in LQR state feedback control system?
显示 更早的评论
Please can anyone help to diagnose the problem with simulink model. I modeled a control system based on LQR control. I want to apply the control to a nonlinear system and i want to use sliding mode observer to estimate the states for full state feedback. However, Eact time I run my simulation, It runs very slowly and when i checked the diagnostics, It shows ALGEBRAIC LOOP in the state feedback gain as shown in the attached picture. I dont know why i get such since i do not need to use any continous block at this point. Thank you 
采纳的回答
Delprat Sebastien
2020-9-24
编辑：Delprat Sebastien
2020-9-27
0 个投票
The algebraic loop does not depends on continous ou discrete nature of the process, but on the direct transfert of the input to the output of your system. In your case, I would bet that the system is exactly proper : the output is y(t)=gain.u(t)+something that depends on state. The same thing could happen in discrete time. If the system is linear, then its transfert function has numerator and denominator of the same order.
It is very likely that some dynamics have been neglected in the system modeling because most of physical systems are strictly proper.
You may fix this by adding an actuator dynamics. Alternatively, adding a memory bloc on the output or the control will solve the problem but it is not so nice.
更多回答（1 个）
类别
在 帮助中心 和 File Exchange 中查找有关 State-Space Control Design 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
