Constant Power Load (CPL) block Simscape Electrical

Question

Krupa Prag 2020-10-13

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/612416-constant-power-load-cpl-block-simscape-electrical

编辑： Aniruddh Maini 2022-9-17

I currently am designing a Buck-Boost Converter using the blocks from powerlib Simulink.

I would like to add a CPL to the circuit. However, this block exists in another library and is not compatible with my current circuit design.

Any suggestions on how to modify the circuit to include this component or would the entire circuit have to be rebuilt using Simscape Electrical library. I would like to use this environment with the reinforcement learning functionalities.

3 个评论
显示 1更早的评论隐藏 1更早的评论

Pemendra Kumar Pardhi 2020-10-13

you can also refer concept same as power electronics circuits for LED.

Krupa Prag 2020-10-14

Thank you for your response.

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Joel Van Sickel 2020-10-14

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/612416-constant-power-load-cpl-block-simscape-electrical#answer_513796

Hello Krupa,

you can build your own constant power load using a controlled source. use a controlled current source and calculate the current using P/V = I. To break the algebraic loop, put a low pass filter between this calculation and the controlled current source. You can create a low pass filter with the transfer function block. Have the numerator = [1] and the denominator = [1/(2*pi*100) 1]. This will not be an ideal constant power load, but will be quite close to a constant power load and can be implemented in any number of circuit simulators.

Regards,

Joel

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Krupa Prag 2020-10-19

Thank you for your response.

请先登录，再进行评论。

Answer 2

Aniruddh Maini 2022-9-17

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/612416-constant-power-load-cpl-block-simscape-electrical#answer_1055305

编辑：Aniruddh Maini 2022-9-17

Hi Joel

Can you please eleborate your answer more clearly or can you please come up with a diagram which clearly depicts how to model a buck converter with Constant power load because I am facing really a hard time modelling a buck converter with CPL which should dissipate constant power?

Thanks