Switching frequency-determining

37 次查看（过去 30 天）
Ahmad Badran
Ahmad Badran 2020-10-15
回答： Rhea Chandy 2020-11-6
how i can determin the switching freqency for the inverter coltage output as it show in the scope ,
is there any features in matlab help in this
  5 个评论
显示 3更早的评论
Ahmad Badran
Ahmad Badran 2020-10-20
hi
Thank you for your answer.
I realy want to do it directlty in simulink model , but i could not succed in this.
is the triggered you are talking about same as in attached. if it is, what would be the trigger signal a the top of subsystem . and what is the input and how i can see the output
Mathieu NOE
Mathieu NOE 2020-10-20
see example attached (R2015a)
the output of the last bloc gives you the period measured between two rising pulses (generated by the hit bloc)
the sampling frequency is 1000 Hz (dt = 1e-3)

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Rhea Chandy
Rhea Chandy 2020-11-6
Hello Ahmad,
A built-in block that determines the switching frequency of a signal is not available in the Simulink library. This previously answered question may help you get some insight on this.
You can also look into this Spectrum Analyzer block to see if it suits your needs.

类别

在 Help Center 和 File Exchange 中查找有关 Pulse and Transition Metrics 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by